To give credit where credit is due: I found this information on and decided to post it to this forum after I used it and it fixed all my remotes. Resetting the remote periodically helps establish connectivity between the remote handheld and the control system. This procedure is not a fix-all procedure. If it properly displays the name of the room it controls, another problem probably exists, but resetting may help. (Default Mode) Delta Connection with Shorted SCR Protection (Optional Mode) 2 1 4 3 2 1 4 3 6 5 6 5 U. When set for External Bypass mode, the SMC Flex can be used to control a properly sized.
To check and see if this procedure can help press the cancel button and view what the display says on the remote. The fan jumpers have been factory installed for 110/120V AC input. *This procedure may change at any time due to updates from Control 4. This procedure usually helps when the Control 4 remote does not properly display the room name it is suppose to control. Keep holding the cancel button until the screen goes blank and then goes to sleep.Ĩ.The remote has now been reset and it will re-establish zigbee communication with its controller the next time the remote is used. If it properly displays the name of the room it controls, another problem probably exists, but resetting may help.ģ.Continue holding the Red 4 button and re-insert the battery.Ĥ.Continue holding Red 4 button until "TEST" appears at the top of the remote's display.Ħ.Press and hold the cancel button. To check and see if this procedure can help press the cancel button and view what the display says on the remote. This procedure usually helps when the Control 4 remote does not properly display the room name it is suppose to control. This procedure may solve most remote problems.